Ask the builder low-voltage deck lights are an easy diy installation the spokesman-review walmart with a gas station near me


Q. I’m going to tackle rebuilding my deck soon and have seen lots of photos of low-voltage deck lighting. I’m afraid of electricity and don’t feel I have the skills to do this part of the project. Can you impart any wisdom that will instill the courage in me to try to do this wiring? Have you worked with an easy DIY system? – Becky, Riverside, California

You may be like Becky. You may want to try to work with electricity but need someone like me to tell you to be brave. The good news is all the wiring needed for a typical low-voltage deck project can be done with no power connected to the circuit.

That’s how I wired up my enormous outdoor deck last year. I’ve got soft LED lights on all four sides of each post cap along my 100-plus-feet of my deck railing, and I’ve got down-facing safety lights at each stair riser. All of the lights and wiring were installed with no electricity at all in the thin low-voltage wires.

All you have to do is connect the lights in a series. There are tiny splice-block connectors that the wires plug into as you daisy-chain all the lights together. Trex provides a handy illustrated manual that helps you make all the right connections.

A transformer converts the normal household 120-volt AC current to low-voltage DC current. After you have all of the low-voltage wires connected to the lights, you plug in this transformer into a photo-voltaic timer just as you’d plug a toaster into a wall outlet. It’s completely safe. The timer plugs into a regular GFCI exterior outlet that you might hire an electrician to install for you under the deck.

Q. Last weekend I was involved in a spirited debate with my husband about building a privacy pergola that would make our small backyard more attractive and private. He insists the pergola needs to have four posts spaced like a table to be stable, but I feel it can be more like a fence with just two or three posts in a row. Pick a side and join the fray! – Kelly, Columbus, Ohio

A. Every time I get a message or email like Kelly’s, I have flashbacks about back-and-forth building and remodeling discussions with my wife. The memories are so vivid I have to shake my head to clear them away. I discovered many moons ago it was in my best interest to find a way to make her dreams come true. Maybe that’s one reason we’ll be celebrating our 44th anniversary this September!

If you made the connection between a privacy fence and a smaller pergola like Kelly did, congratulations. Not only can you build a small pergola with two or three posts in a row, but it can also be moored to the ground so it won’t blow or fall over.

The pergola cross members that are connected to the top beam can be up to 6-feet long. It’s important to realize they should be centered on the beams that are going to be connected to each side of the vertical posts for the greatest stability. However, you can cantilever the pergola cross members using a 2:1 ratio for more shade on one side of this privacy structure.

You don’t have to surround the posts with concrete. Concrete becomes a liability in the future if you have to replace a post. I’ve had great success using crushed angular gravel. I surround the post on all sides with at least 4 inches of the gravel. The gravel ranges in size from sand up to pieces not much larger than a big grape.