Deluxe retriev-r-trainer dummy launcher kit. $139.95. free shipping us48 electricity projects ks2

Includes the Retriev-R-Trainer dummy launcher, a white RRT Canvas Dummy, a white Plastic Dummy with red tail, RRT cleaning kit, 100 rounds of medium power charges / dummy loads and RRT instructions — all in a custom fitted carrying case. Recommended. Manufactured in the USA.

gunfire. The use of "heavy" loads will shorten the useful life of the dummies. To prevent molding or premature deterioration, dry the canvas dummy thoroughly following retrieves in water. Increased distance can be obtained by using the plastic dummy and by varying the angle of fire.

NOTE: When training on water, make sure the launch tube in each dummy is dry before re-launching. If water is in the launch tube when the dummy is placed on the launcher, it can enter the firing port, drowning the load and causing a misfire. We recommend having multiple dummies available so the wet ones can dry between launches.

The Retriev-R-Trainer is a practical aid for training retrievers. Training dummies designed for the use with it can be power thrown two to three times farther than hand thrown dummies. They are useful on land or water. Extra dummies can be used to throw doubles, triples, etc. The Retriev-R-Trainer uses blank power charges for throwing power. The accompanying report eliminates the need for a blank pistol.

User must thoroughly clean the barrel, chamber, and hinge areas with a good gun cleaning solvent after each use. Failure to properly maintain the RRT Launcher may result in serious injury or death. You may purchase the RRT Cleaning Kit to simplify this process. A small amount of gun oil applied to the hinge area after cleaning will help to insure smooth operation. Cleaning of the chamber can be enhanced by using a .22 caliber wire brush. Also, thoroughly clean and dry the inside of the dummy tube after each launch to be certain that, prior to each time you launch the dummy from your launcher, it is free of debris both internally and externally. Failure to properly maintain the aluminum insert tube in your dummy may result in serious injury or death. A rubber "O" Ring in a grove near the outer end of the barrel provides a seal for the release gases of the power charge. This "O" Ring will wear causing some of the gases to escape, thereby reducing the flight distance of the dummy. Apply a thin coat of Vaseline, or any other lubricant safe for use on rubber components, to prevent drying and cracking of the o-ring. Replacement "O" Rings are available separately.

Preparation for Firing: • Place an RRT training dummy over the barrel and slide it down. The distance of the throw can be controlled by how far the dummy is placed down the barrel — all the way for maximum distance, less for shorter throws.

• Open the breech by pressing the thumb release/latch located in the middle of the launcher just above the hand grip. The launcher will now pivot open exposing the open chamber for receiving the blank power charge. Fully seat the charge in the chamber as you would a single shot rifle or shotgun.

Firmly grasp the launcher handle in one hand with the thumb latch oriented toward the shoulder of the holding arm. The heel of the holding hand should be facing the thumb latch and your fingers should be wrapped firmly around the grip. Your thumb will be closest to the Pull Knob. Bend the elbow slightly and position the launcher about waist high and one foot from you body. Aim about 45° from the horizontal off to your side toward the target area. Pull the firing knob back to its fully extended position and release it to launch.

Your RRT Launcher is not a firearm, but the same handling, care, and safety precautions must be exercised. Your Retriev-R-Trainer is provided with certain built-in safety features, but these are not substitutes for safe handling practices, which include the use of ear and eye protection as well as the use of heavy leather gloves.