Project discussion – newbie with zero knowledge. – shop floor talk year 6 electricity assessment

############

I recently went to another machinist forum, and read a few posts to try electricity distribution costs to get an idea, only to see a thread where all these professional machinists utterly destroyed a newbie for asking a simple question. They did it in a hateful, hurtful, and rather sadistic manner, and appeared to openly enjoy it. I don’t think that’s the attitude here, after reading several threads. But please, remember that there was a time when you knew nothing, and gas near me open now be patient with me. Thanks!

I would like to learn how to adequately and properly describe two small metal pieces I would like to eventually mp electricity bill pay indore have made. First and foremost, I’m not Warren Buffett, and would prefer not to sell my firstborn or mortgage my house to have this done. In other words, I’d like to eventually get it done for a fair price, on the cheap, as embarrassing as it is to say that.

Before I describe the pieces I’m talking about, let me try to describe where I’m coming from. I have some moderate woodworking electricity in the body background, and the level I’m at is, if someone came and said, I have this piece of wood, and I need a 5/16 hole in it where that pencil mark is, I’d pull out a 5/16 drill bit gas vs electric oven cost, and drill the hole where the pencil mark is. I can hear the gasps of horror already, over the lack of rocket-parts precision. On some of the forums where I’ve tried to read posts about metal working, I keep seeing all these zeros. For example, precision levels that could only gas news uk be determined with the use of a microscope. I don’t need that. It isn’t necessary electricity magnetism. Really.

I have in mind, these two pieces of flat steel bar. (yes, I know there are hundreds, if not thousands of alloys, but again, I don’t have the specific knowledge to be able to name one) They should be inexpensive, readily-available, regular plain old steel. They are both 3-1/2 long, 1 wide, and have grooves on one side that electricity wikipedia simple english run the long way. They also both have a pair of 1/2 holes in them gas national average 2013. One of them is flat on the other side of the grooves, and is 1/4 thick. The other is 3/8 thick, and has a rounded groove on the other side of the longitudinal grooves. I have attached a very rough sketch of these pieces, so everyone can see clearly what electricity lesson plans year 6 I’m talking about.

I’ve made three sets of these things out of reclaimed pallet wood, and never used anything to measure other than a Stanley tape measure. I have a decent router, and a pretty old standing drill press, but that’s as complicated as it got. And I even used old wood from a broken-down pallet. If my piece of wood is 10 inches long, and I need a hole in the middle of it, then I measure 5 inches grade 6 electricity unit plan from one end, and when was gas 99 cents in california presto! There’s the middle. If I want to be careful, I measure from the other end too. Yep, the pencil mark came out in the same place. That’s the middle, pull out that drill bit that’s 1/2 in diameter, and drill away.

What I don’t understand is, how gas monkey monster truck can I make these things out of wood, and have them be perfectly what I want, and now they suddenly have to have all this math, precision, and detail? I just don’t get that. It doesn’t have to be as difficult as this. A half-inch hole is a half-inch hole gas near me prices is a half-inch hole, and anyone thinking it needs to be 0.000000X precise is just making it far too unnecessarily complicated. That’s just ego. If it’s anything else, like say, 9/16 then it isn’t a half-inch hole, is it?